Electrical 7
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
Plug Type Voltage Selector
Voltage is set to 230V. To change to 115V:
1. Make sure power is off.
2. Pull the voltage change plug off of the tabs.
3. Move the voltage change plug to the 115V position.
The plug will now cover 2 metal tabs and the arrow
on the plug will line up with the 115V arrow on the
label (see Figure 7).
4. Attach the incoming power leads to the two outer
screws on the pressure switch as shown in Figure6.
5. Attach the ground wire to one of the grounding
connections, shown in Figure 6.
6. If there are other wires, they should be capped.
7.
Reinstall the motor end and pressure switch covers.
Dial Type Voltage Selector
Voltage is set to 230 volts. To change to 115 V:
1. Make sure power is off.
2. Turn the dial counter-clockwise until 115 shows in
the dial window as shown in Figure 9.
3. Attach the incoming power leads to the two outer
screws on the pressure switch as shown in Figure 8.
4. Attach the ground wire to the grounding connections
as shown in Figure 8.
5. If there are other wires, they should be capped.
6.
Reinstall the motor end and pressure switch covers.
Disconnect power before working on pump, motor, pressure switch, or wiring.
Motor Switch Settings
NOTICE: 1/2 HP motors are dual voltage and are factory set to 115V. 3/4 & 1 HP motors are also dual voltage, but are
factory set to 230V. Motor terminal board (located under the motor end cover) should look like that shown below. Use
the instructions to set your motor to match your power source.
Never connect a motor set to 115V to a 230V power source.
Figure 6: Voltage set to 230V, Plug Type
Ground Wire Connection
Voltage Change Plug
Pressure Switch
Power Connections
Figure 7: Voltage set to 115V, Plug Type
Figure 8: Voltage set to 230V, Dial Type
Ground Wire Connection
Power Supply Connections
Voltage
Change
Dial
Pressure Switch
Figure 9: Voltage set to 115V, Dial Type
Komentáře k této Příručce